Hydraulic oil fix & stabilizer CASE OF 6 Bottles

  
Do you have milky, contaminated hydraulic fluid in your equipment? We have the fix with Hydraulic Oil Fix and Stabilizer. This is the environmentally friendly way to deal with milky watery hydraulic oil with our PATENT PENDING product. It does not contain PETROLEUM distillates, Glycol or alcohol. See it in action in the video. WORKS FOR OIL SYSTEM FLUSH. All oils, including new oils, are affected by water. In oil has no lubrication and causes stiction/overall loss of productivity. Molecules actively seek other molecules, including metals. Additives, antioxidants, friction modifiers, and anti-wear. Water will come out of suspension and form white gummy masses. In various areas of the unit that cannot be flushed. Any oil with water exceeding 300.

PPM is corrosive leading to rust, hydrolysis, and sludge. Emulsified water can cause oil. To behave unexpectedly, and can cause clogged filters, and increased oil acidity. Made in USA at the factory in Conway SC.

Determine the total oil capacity of the wet system including tank, hoses, valves, etc. IN EQUIPMENT WITH CLEAN OIL (NO MILKY / EMULSIFIED OIL DETECTED).

ADD 1% of OIL FIX of the total wet system capacity. IF MILKY / EMULSIFIED OIL IS DETECTED. ADD 3% of OIL FIX of the total wet system capacity.

Run & mix thoroughly until oil is clear. Drain oil system and replace with new oil. To extend the life of the new oil, add up to 1% of OIL FIX (see STEP 1). OIL HAS BEEN CHANGED BUT MILKY / EMULSIFIED OIL IS STILL DETECTED.

Results will improve over time. AT ANY TIME, DO NOT LET THE AMOUNT OF MIB HYDRAULIC OIL FIX & STABILIZER IN THE ENTIRE SYSTEM EXCEED 3% OF THE TOTAL SYSTEM CAPACITY.